Eneo DMR-104 Provozní pokyny stáhnout pdf (Strana 14)

User’s Manual

Audio In/Out

NOTE: It is the user’s responsibility to determine if local laws and regulations permit recording audio.

The DVR does not have amplified audio output, so you will need a speaker with an amplifier. The DVR

does not have a pre-amplifier for audio input, so the audio input should be from an amplified source, not

directly from a microphone.

Video Out

NOTE: When using HDMI monitors, change the monitor display mode to HD mode by setting the HD/SD Out

selector on the rear panel to the HD OUT position. HDMI video out will only enable in the HD display mode.

VGA video out on the primary monitor will disable in the SD display mode.

Composite (BNC) video out on the primary monitor will disable in the HD display mode.

Monitor Connection Examples:

< HD Display Mode >

< SD Display Mode >

NOTE: Connect the monitor before the DVR boots so that video can be displayed on the monitor with the resolution

you have set during system setup.

Your DVR can record audio from up to 16 sources. Connect the audio

sources to Audio In 1 to Audio In 16 as needed using RCA jacks. Connect

Audio Out to your amplifier. Use the provided audio extension cable to

connect the audio sources to Audio In 5 to 16.

A HDMI (High-Definition Multimedia Interface) connector is provided so that you can use a HDMI

monitor as your primary monitor. Use the cable supplied with your monitor to connect it to the DVR.

A VGA connector is provided so that you can use a standard, multi-sync computer monitor as your

primary or secondary monitor. Use the cable supplied with your monitor to connect it to the DVR.

Connect the primary or secondary monitor to the Video Out connector.

Connect the spot monitor to the SPOT connector as needed.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 87 88

Žádné komentáře

Eneo DMR-104 Provozní pokyny Strana 14