Eneo GLC-1601 Provozní pokyny stáhnout pdf (Strana 54)

6.1.7 Change the Pan/Tilt Setting

Click the Pan/Tilt button on the home page to open the Speed Dome Controller.

1. Click „Conﬁgure” to enter to the RS485 setting page (please refer to Change the System Setting - RS485 Setting).

2. Select a Speed Dome device ID from the drop-down list on the Speed Dome Controller. The Controller will display

the corresponding ID.

3. Each of the ten buttons under ‚Set’ is connected with a speciﬁc position and angle of either panning or tilting of

the camera. Click each button to activate its particular position and angle. Press the button under ‚Preset’ to turn

the camera angle by angle in the set positions. Each of the ten buttons designated ‚Go to’ can be clicked to view

the particular corresponding angle of the position in which it is set.

4. Select the connecting port. The RS-232 communication port functions as a connector to an external control device.

5. Upon the buttons being clicked, a camera will move one short step only in any of the four designated directions.

6. Click the buttons to control the Focus setting on the Speed Dome Controller. Click

„+” button to focus far and click

the „–” button to focus near.

7. Click the buttons to control the Zoom setting on the Speed Dome Controller. Click

„+” button to zoom in and click

the „–” button to zoom out.

8. Upon the buttons being clicked, a camera will turn all the way, without stopping, in one of the four designated

directions.

9. Click the buttons to control the Aperture setting on the Speed Dome Controller.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 103 104

Žádné komentáře

Eneo GLC-1601 Provozní pokyny Strana 54